Initial SettingsConfiguring the IP Address on the Printer ...................................................................................................... 699Configuring the IP Address Using the Printer Control Panel ...................................................................... 700Configuring the IP Address Using ARP and PING Commands .................................................................. 701Configuring TCP/IPv6 Network Settings ......................................................................................................... 702Configuring the Printer Driver Destination (Windows) .................................................................................... 703Configuring the Printer Driver Destination (Mac OS X) ................................................................................... 704Configuring the Printer's TCP/IP Network Settings With RemoteUI ................................................................ 704Configuring the IP Address on the PrinterYou must configure the printer's IP address before using the printer in a TCP/IP network.The printer's IP address is configured automatically when you install the printer driver following the instructions in the Set-up Guide.Configure the IP address by using imagePROGRAF Device Setup Utility, the printer Control Panel, or ARP or PING com-mands, if the IP address is changed, or if you change the printer connection mode to a network connection. For details onconfiguring the IP address, refer to the following topics.• Configuring the IP Address Using imagePROGRAF Device Setup Utility →P.408 (Windows)• Configuring the IP Address Using the Printer Control Panel →P.700• Configuring the IP Address Using ARP and PING Commands →P.701Important• If you use a DHCP server for automatic assignment of the printer's IP address, printing may no longer bepossible after the printer is turned off and on. This is because an IP address different from before has beenassigned. Thus, when using DHCP server functions, consult your network administrator and configure thesettings in one of the following ways.• Configure the setting for dynamic DNS updatingIn the printer menu, either set DNS Dync update to On, or activate the setting Enable DNS DynamicUpdate in RemoteUI.(See "Menu Settings.") →P.673(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.") →P.704• Configure the setting for assignment of the same IP address each time the printer starts upNote• We recommend configuring the printer's IP address even if you will use the printer in networks other thanTCP/IP networks. Configuring the printer's IP address enables you to use RemoteUI to configure the networksettings and manage the printer with a web browser.For details on RemoteUI, see "Using RemoteUI." →P.696Network Setting > Initial Settings >iPF750 Configuring the IP Address on the Printer9699
