Note• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors orthe blade after removing creased edges. (See "Specifying the Cutting Method for Rolls.")→P.594Changing the Type of PaperFollow these steps to change the type of paper specified on the printer after you have loaded paper.If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of config-uring the media type setting when you load the paper again. The current media type settings before you select On will beautomatically selected at that time. (See "Using the Same Type of Paper Regularly.") →P.584Important• For best printing results, the printer fine-tunes the print head height and the feed amount for each type ofpaper. Be sure to select the type of paper to use correctly before printing.• Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printedimages may vary depending on the type of paper used. If margins and the size of images are not as you ex-pected, adjust the paper feed amount.(See "Adjusting the Feed Amount.") →P.628Changing the Type of PaperNote• When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select thetype of paper, and then press the OK button.If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the rolllength after the type of paper. (See "Specifying the Paper Length.") →P.5851. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Paper tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2. Press the OK button.The Paper Menu is displayed.3. Press ▲ or ▼ to select Chg. Paper Type, and then press the OK button.4. Press ▲ or ▼ to select the type of paper loaded ( Roll Paper or Cut Sheet), and then press the OK button.Handling Paper > Handling rolls >iPF750 Changing the Type of Paper5583
