Canon imagePROGRAF iPF750 MFP M40 User Manual

Also see for imagePROGRAF iPF750 MFP M40: Install guide Basic guide Basic guide Brochure Basic guide

Contents

Canon imagePROGRAF iPF750 MFP M40 User Manual Manual pdf 743 page image

Security SettingsItem Details Default SettingNew Password Enter the new password.(0-9999999)blankConfirm Enter the new password again to confirm it.(0-9999999)blank*1: On the Security settings screen, besides entering a password, you can specify other security-related information,such as IP address-based SNMP or TCP usage restrictions, MAC address-based access restrictions, or IPP andFTP authentication settings.7. Click OK to activate the settings.Configuring the Communication Mode ManuallyThis topic gives instructions for configuring the communication mode manually.1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2. Press the OK button.The Set./Adj. Menu is displayed.3. Press ▲ or ▼ to select Interface Setup, and then press the OK button.4. Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.5. Press ▲ or ▼ to select Auto Detect, and then press the OK button.6. Press ▲ or ▼ to select Off, and then press the OK button.The display reverts to the Ethernet Driver menu.7. Press ▲ or ▼ to select Comm.Mode, and then press the OK button.Network Setting > Other Settings >iPF750 Configuring the Communication Mode Manually9727