8-11Maintenance5 Remove the toner cartridge.6 Take out the new toner cartridge from theprotective bag.You can open the protective bag with your hands from the notch.7 Gently shake the toner cartridge five or six timesto evenly distribute the toner.8 Place the toner cartridge on a flat surface,remove the tab, and gently pull the sealing tapecompletely out.The full length of the sealing tape is approximately 20” (50 cm).(2)(1)9 Insert the toner cartridge.Fit the protrusions (A) on each side of the toner cartridge into theguides located on each side of the machine, and then slide thetoner cartridge into the machine until the toner cartridge meetsthe back of the machine.(A)(A)10 Close the toner cover.If you cannot close the toner coverEnsure that the toner cartridge is properly set in the machine.Do not try to forcefully close the toner cover, as this may damagethe machine.11 Lower the scanning platform.Precautions when Replacing Toner CartridgeSee “Maintenance and Inspections” (P.xv) in “ImportantSafety Instructions” as well.WARNINGDo not dispose of a used toner cartridge in openflamesThis may cause the toner remaining inside the cartridgesto ignite, resulting in burns or fire.CAUTIONPrecautions if you get toner on your hands orclothingIf toner gets on your hands or clothing, wash themimmediately with cold water.Washing with warm water sets the toner, making itimpossible to remove the toner stains.Be careful not to allow the toner to scatterDo not pull out the sealing tape forcefully or stop atmidpoint, as this may cause toner to spill out.If toner gets into your eyes or mouth, wash themimmediately with cold water and consult a physician.Precautions when lowering the scanning platformBe careful not to catch your fingers.
