122You can cut out a portion of a recorded image and save it as a new image file.Select [Trimming].● Press the n button, select the 1 taband [Trimming], then press the m button.Select an image.● Press the qr buttons to select the imageand press the m button.Adjust the trimming area.X A green frame will appear around theportion of the image to be trimmed.X The original image will display in the upperleft and the trimmed image will display inthe lower right.● If you move the zoom lever to the left orright, you can change the frame size.● If you press the opqr buttons, you canmove the frame.● If you press the l button, you canchange the vertical/horizontal orientationof the frame.● In an image with a detected face, a grayframe will appear around faces located inthe upper left of the frame, and the framecan be used for trimming. You can switchbetween frames by pressing the mbutton.● Press the n button.Save as a new image and display.● Perform Steps 4 and 5 on p. 121.[ TrimmingTrimming Area DisplayTrimming AreaRecorded pixelsafter trimming• , and images cannot be trimmed.• Trimming is only possible for images shot at aspect ratio 4:3 (vertical 3:4).• The number of recorded pixels in a trimmed image will be smaller thanbefore trimming.COPY
