|
Chapter 11 165Troubleshooting*[##] represents a two-digit figure.The paper size is not correct.Change the page size you have set.The paper size setting is set to a size other than , <8.5" x 11">, or<8.5" x 14">.Reset the paper size in the Settings screen. When feeding from the AutoSheet Feeder, set it to , <8.5" x 11">, or <8.5" x 14">. When feedingfrom the cassette, set it to or <8.5" x 11">.Change the paper. A4/8.5x11/8.5x14PlainChange the paper. A4/8.5x11 PlainpaperNoteAdjusting the Print Head ManuallyIf the Automatic Print Head Alignment does not work or if you wish to adjust the print headsmanually, follow the procedure below.1. Press [ON/OFF] to turn on the machine, and then load two sheets of A4/Letter-sizedplain paper in the Auto Sheet Feeder or Cassette. See “Turning the Machine ON andOFF” on page 18, and “Loading Paper” on page 22.2. Ensure that the proper paper source is selected.3. Display the Maintenance screen.4. Use [ ] or [ ] to select , then press [OK].5. Use [ ] or [ ] to select , then press [OK].The Print Head alignment pattern is printed.6. When is displayed, confirm that the pattern is printedcorrectly, use [ ] or [ ] to select , and then press [OK].The input screen for the head position adjustment value is displayed.7. Check the printed patterns and use [ ] or [ ] to input the number of the pattern incolumn A that has the least noticeable streaks.8. Press [ ] to move the cursor to column B, and then use [ ] or [ ] to input thenumber of the pattern that has the least noticeable streaks.9. Repeat the procedure until you finish inputting the pattern number for column P.10.When you have finished inputting all pattern numbers, press [OK].Message Action
|
