Canon CLC5100 Series Manual

Contents

Canon CLC5100 Series Manual Manual pdf 79 page image

Chapter 22-27Be sure to disconnect the power plug from thepower outlet. Merely turning off the power switchwill not cut the power.4) Replace the DC controller PCB.5) Turn on the power switch.6) Initialize the RAM on the DC controller PCB. (Seethe appropriate instructions.)7) Turn on and then off the power switch.2.7.4 Initializing the RAMon the DC controller PCB 0002-5879CLC5100 / CLC40001) Record the setting of 'OFFSETC/M/Y/K' found inthe second row of page 2 on the EPC screen of'FUCNT' in service mode.2) Start service mode, and check to make sure that'BELTPOS' of 'BLTDRFT' under 'DISP' is'CENTER'; if not, move the transfer belt to thecenter.3) Execute 'FUNC>DCCON>RAMLR' in servicemode.4) Turn off the power switch, and disconnect and thenconnect the power plug (so that the RAM will becleared).5) Turn on the power switch.6) If you have replaced the DC controller PCB,replace the developer according to the instructionson Replacing the Developer.7) Enter the value of A recorded on the service label.(If you have changed other service mode settingsrelated to the DC controller, enter such settings aswell.)8) Execute 'REGAPER' of 'INSTALL2' under'FUNC' in service mode.9) Enter the setting of 'OFFSET C/M/Y/K' recordedin step 1) to the following: 'FUNC>DCCON>POTOFSTC/M/Y/K'.The settings on the screens of service mode arecleared when the RAM on the reader controller PCBis initialized.T-2-4The settings on the screens of service mode arecleared when the RAM on the DC controller PCB isinitialized.T-2-5Service Mode Settings Related to the DC ControllerPCBADJUST Settings on ADJXY screenSettings on DOCREC screenSettings on PROJ screenSettings on ED/RF screenSettings on COLADJ screenSettings on ADJMISC screenSettings on PRJADJ screenOPTION Settings on POPT screenSettings on ONSET on POPTscreenSettings on REMOTE screenSettings on DECK screenADJUST Settings on PASCAL screenSettings on FEEDADJscreenSettings on ENVSET screenSettings on HVTR C/M/Y/KscreenSettings on HVSP screenSettings on HVFS screenSettings on HVEL screenFUNC Settings on DCCON screenSettings on PUPTMGscreenSettings on PTHICK screenSettings on IMGREG screenSettings on FUSER screenOPTION Settings on POPT screen(except ONSET))