|
Chapter 22-10 Using the TwoSided Copies as the source of PaperLoosen the screw [1], and adjust the position of thepaper guide plate so that the standard value is attained.F-2-15b. Adjusting the Image MarginF-2-161) Start service mode, and select 'ADJUST > FEEDADJ'.2) While the 'FEEDADJ' screen is on, press the Startkey.3) If the image margin is not as indicated, adjust theimage writing start position in the main scanningdirection using 'UPADJ', 'LOWADJ', 'MULTADJ', 'DECKADJ', and 'REFEADJ' and using'VSYCADJ' in the sub scanning direction.Then, adjust the nonimage width using 'MARGINL,R, T, B'.(For details, see. "SERVICE MODE.")2.2.4 Adjusting the ImageReading Start Position(ADJXY) 0002-3604CLC5100 / CLC4000F-2-171) Start service mode, and select 'ADJUST > ADJXY'.2) While the 'ADJXY' screen is on, press the Startkey. The appropriate copying mode will be setautomatically, and a copy is made with a shift ofabout 20 mm as shown in the Figure.3) If a portion of the image is missing, decrease thesetting of 'ADJX' and 'ADJY'.4) If an area outside the image area is copied, increasethe setting of 'ADJX' and 'ADJY'.5) Press the Start key once again, and check theoutput.6) Press the Reset key.F-2-18[1] ADJ-XY READY DISPADJUSTCOUNTERFUNCOPTIONADJ-YADJ-SADJ-JTESTADJ-Xxxxxxxxxxxxxxxxx
|
