2-88HomeLink TransmitterThis device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and(2) this device must accept any interference received,including interference that may cause undesiredoperation.This device complies with RSS - 210 of Industry Canada.Operation is subject to the following two conditions:(1) this device may not cause interference, and (2) thisdevice must accept any interference, includinginterference that may cause undesired operation ofthe device.Changes and modifications to this system by other thanan authorized service facility could void authorization touse this equipment.Programming the HomeLink TransmitterDo not use the HomeLink Transmitter with any garagedoor opener that does not have the stop and reversefeature. This includes any garage door opener modelmanufactured before April 1, 1982.Be sure that people and objects are clear of the garagedoor you are programming.It is recommended that a new battery be installed inyour hand- held transmitter for quicker and moreaccurate transmission of the radio frequency.Your vehicle’s engine should be turned off whileprogramming the transmitter. Follow these steps toprogram up to three channels:1. Decide which one of the three channels (one of theHomeLink buttons) you want to program.2. Press and hold the desired button on HomeLinkthrough Step 3.3. When the HomeLink indicator light begins to blinkslowly (this may take up to 30 seconds), hold thehand- held transmitter about 1 to 3 inches (3 to 8 cm)away from HomeLink and then press and hold thetransmit button on the hand- held transmitter.Continue to hold both buttons until the indicatorlight on HomeLink begins to flash rapidly (this maytake up to 90 seconds).
