Setting Preset StationsThe RDS PTY mode must be off to set preset stations.Up to 36 stations (six weather, six FM1, six FM2,and six AM, six XM1 and six XM2 (if equipped), can beprogrammed on the six numbered pushbuttons, byperforming the following steps:1. Turn the radio on.2. Press BAND to select weather, FM1, FM2, AM, orXM1 or XM2.3. Tune in the desired station.4. Press and hold one of the six numberedpushbuttons for more than two seconds until youhear a beep. Whenever that numbered pushbuttonis pressed for less than two seconds, the stationthat was set will return.5. Repeat the steps for each pushbutton.When battery power is removed and later applied,you will not have to reset the radio presets.Setting the Tone (Bass/Treble)TONE: Press and release this button until BASS,TREBLE, or MIDRANGE appears on the display.The radio keeps separate tone settings for each band,preset (except weather band presets), and source.− LEVEL +: After selecting the desired tone control,press the plus or minus button to select thedesired level.To save the tone settings for the presets, press andhold the numbered pushbutton for the desired preset formore than two seconds until you hear a beep.Adjusting the Speakers (Balance/Fade)TONE: Press and release this button until BALANCEor FADE appears on the display.− LEVEL +: After selecting the desired control, pressthe plus or minus button to select the desired level.To save the tone settings for the presets, press and holdthe numbered pushbutton for the desired preset formore than two seconds until you hear a beep.3-90
