Playing the RadioPWR (Power): Press this knob to turn the system onand off.VOL (Volume): Turn this knob to increase or todecrease the volume.Finding a StationBAND: Press this button to switch between weather,FM1, FM2, AM, or XM1 or XM2 (if equipped).The display will show the selection.¦TUNE SEEK ¥: This button can be pressed totwo positions. Press this button to the first position totune to the next or to the previous frequency. If thisbutton is held at the first position for a few seconds, theradio will continue tuning until this button is released.Press this button to the second position and release it togo to the next or to the previous radio station andstay there.The radio will only seek stations with a strong signalthat are in the selected band.RDM (Random): For XM™ (if equipped), press theRDM button while in XM mode to retrieve four differentcategories of information related to the current songor channel: Artist Name/Feature, Song/ProgramTitle, Channel Category.SCAN: Press this button for less than two seconds toscan radio stations. The radio will go to a station,play for five seconds, then go on to the next station.Press this button again to stop scanning.To scan preset stations, press and hold SCAN for morethan two seconds until you hear a beep. The radio will goto the first preset station stored on the pushbuttons, playfor five seconds, then go on to the next preset station.Press SCAN again to stop scanning presets.The radio will only scan stations with a strong signal thatare in the selected band.Setting Preset StationsUp to 36 stations (six weather, six FM1, six FM2,six AM, and six XM1 and six XM2 (if equipped)), can beprogrammed on the six numbered pushbuttons, byperforming the following steps:1. Turn the radio on.2. Press BAND to select weather, FM1, FM2, AM, orXM1 or XM2.3. Tune in the desired station.4. Press and hold one of the six numberedpushbuttons for more than two seconds until youhear a beep. Whenever that numbered pushbuttonis pressed for less than two seconds, the stationthat was set will return.5. Repeat the steps for each pushbutton.3-82
