Using HomeLink®Press and hold the appropriate HomeLink® button forat least half of a second. The indicator light will come onwhile the signal is being transmitted.Erasing HomeLink® ButtonsTo erase programming from the three buttons do thefollowing:1. Press and hold down the two outside buttons untilthe indicator light begins to flash, after 20 seconds.Do not hold the two outside buttons for longerthan 30 seconds.2. Release both buttons.HomeLink® is now in the train (learning) mode and canbe programmed at any time beginning with Step 2under “Programming HomeLink® ” shown earlier inthis section.Individual buttons cannot be erased, but they can bereprogrammed. See “Reprogramming a SingleHomeLink ® Button” following this section.Reprogramming a Single HomeLink®ButtonTo program a device to HomeLink® using a HomeLink®button previously trained, follow these steps:1. Press and hold the desired HomeLink® button.Do not release the button.2. The indicator light will begin to flash after20 seconds. While still holding the HomeLink ®button, proceed with Step 2 under “ProgrammingHomeLink® ” shown earlier in this section.Resetting DefaultsTo reset HomeLink® to default settings do the following:1. Hold down the two outside buttons for about20 seconds until the indicator light begins to flash.2. Continue to hold both buttons until the HomeLink®indicator light turns off.3. Release both buttons.For questions or comments, contact HomeLink®at 1-800-355-3515, or on the Internet atwww.homelink.com.2-48
