EQ (Equalization): For the non-Bose® amplified radio,perform the following steps to setup the equalizationsettings:1. Press the a knob until the equalization labeldisplays.2. Press the pushbutton located under the equalizationlabel to get choices of POP, ROCK, CTRY (country),TALK, JAZZ, and CLAS (classical), to display.3. Press the pushbutton located under the desiredsetting.For the Bose amplified radio, perform the followingsteps to setup the equalization settings:1. Press the a knob until the DSP label displays.2. Press the pushbutton located under the DSP labelto get choices of Norm, Driv, Rear, and Surround,to display.3. Press the pushbutton located under the desiredsetting.To select Surround, press either the fourth or fifthpushbutton located under the displayed Surrounduntil Centerpoint displays.To return to the manual mode, press the tune knob.Select either BASS, MID, or TREB and start to manuallyadjust the settings by turning the a knob.Adjusting the Speakers (Balance/Fade)BAL/FADE (Balance/Fade): To adjust balance or fade,press the a knob until the speaker control labels display.Continue pressing to highlight the desired label, or pressthe pushbutton positioned under the desired label.Turn the a knob to adjust the highlighted setting.The highlighted setting can be adjusted by pressingeither SEEK arrow, \ FWD, or s REV buttonsuntil the desired levels are obtained.To quickly adjust balance or fade to the middle position,press the pushbutton positioned under the BAL or FADElabel for more than two seconds. A beep sounds and thelevel adjusts to the middle position.To quickly adjust all speaker and tone controls to themiddle position, press the a knob for more thantwo seconds until a beep sounds.3-103
