Windshield Washer{ CAUTION:In freezing weather, do not use your washer untilthe windshield is warmed. Otherwise the washerfluid can form ice on the windshield, blocking yourvision.J (Washer Fluid): Press and release this paddle,located at the top of the turn signal/multifunction lever,to spray washer fluid on the windshield. The wiperswill clear the windshield and either stop or return to thepreset speed. For more washer cycles, press and holdthe paddle._ (Heated Washer Fluid): The heated windshieldwasher fluid system, if the vehicle has this feature,may be used to help clear ice, snow, tree sap, or bugsfrom the windshield. Slide the control on the turn signal/multifunction lever to this position and then release, toactivate the heated windshield washer fluid system.This activation initiates four heated wash/wipe cycles.The first heated wash/wipe cycle may take up to40 seconds to occur, depending on outside temperature.After the first wash/wipe cycle, it may take up to20 seconds for each of the remaining cycles. The heatedwindshield washer fluid system may be turned off at anytime by sliding the control on the turn signal/multifunctionlever to this position again.When the heated windshield washer fluid system isactivated under certain outside temperature conditions,steam may flow out of the washer nozzles for a shortperiod of time before washer fluid is sprayed. This is anormal condition.WASHER FLUID LOW ADD FLUID will be displayed onthe Driver Information Center (DIC) when the washerfluid is low. See DIC Warnings and Messages onpage 3-73.3-15
