See your dealer/retailer or a locksmith who can servicePASS-Key® III+ to get a new key blank that is cutexactly as the ignition key that operates the system.To program the new key:1. Verify that the new key has a 1 stamped on it.2. Insert the original, already programmed, key in theignition and start the engine. If the engine will notstart, see your dealer/retailer for service.3. After the engine has started, turn the key toLOCK/OFF, and remove the key.4. Insert the new key to be programmed and turn it tothe ON/RUN position within five seconds of turningthe original key to LOCK/OFF.The security light will turn off once the key hasbeen programmed.5. Repeat Steps 1 through 4 if additional keys are tobe programmed.If you lose or damage your PASS-Key® III+ key, seeyour dealer/retailer or a locksmith who can servicePASS-Key® III+ to have a new key made.Do not leave the key or device that disarms ordeactivates the theft deterrent system in the vehicle.Starting and OperatingYour VehicleNew Vehicle Break-InNotice: The vehicle does not need an elaboratebreak-in. But it will perform better in the long run ifyou follow these guidelines:• Do not drive at any one constant speed, fast orslow, for the first 500 miles (805 km). Do notmake full-throttle starts. Avoid downshifting tobrake or slow the vehicle.• Avoid making hard stops for the first 200 miles(322 km) or so. During this time the new brakelinings are not yet broken in. Hard stopswith new linings can mean premature wear andearlier replacement. Follow this breaking-inguideline every time you get new brake linings.• Do not tow a trailer during break-in. See Towinga Trailer on page 4-28 for the trailer towingcapabilities of your vehicle and moreinformation.Following break-in, engine speed and load can begradually increased.2-24
