Turn Signal OnIf you drive your vehicle for more than about 1 mile(1.6 km) with a turn signal on, this message will appearas a reminder to turn off the turn signal. A multiplechime will sound when this message is displayed.DIC Vehicle PersonalizationYour vehicle has personalization that allows you toprogram certain features to a preferred setting for up totwo people. The number of programmable featuresvaries depending upon which model of the vehicle ispurchased.On all vehicles, features such as climate control settings,radio preset settings, exterior lighting at unlock, remotelock and unlock confirmation, and automatic door lockshave already been programmed for your convenience.Some vehicles have additional features that can beprogrammed including the seat and outside rearviewmirror position.If your vehicle has the ability to program additionalpersonalization features, the driver’s preferences arerecalled by pressing the unlock button on the remotekeyless entry transmitter, 1 or 2, or by pressing theappropriate memory button, 1 or 2, located on thedriver’s door. Certain features can be programmednot to recall until the key is placed in the ignition.To change feature preferences, see “Entering thePersonalization Menu” following.Entering the Personalization MenuTo enter the feature programming mode, use thefollowing procedure:1. Turn the ignition to ON, but do not start the engine.Make sure an automatic transmission is in PARK (P)or a manual transmission has the parking brake set.2. If your vehicle has memory settings, press theappropriate memory button, 1 or 2, located onthe driver’s door armrest. The DIC display will showeither Driver 1 or 2 depending on which buttonwas selected.3. Press the TUNE/SEL knob once to access the mainmenu of the DIC.4. Turn the TUNE/SEL knob until SETUP ishighlighted.5. Press the TUNE/SEL knob once to access theSETUP menu.6. Turn the TUNE/SEL knob until the feature you wantto change is highlighted, then press the TUNE/SELknob to turn the feature on or off. If the featureis turned on, a check mark will appear next to thefeature name.If none of the personalization items are turned on,turn on the personalization menu by pressingthe TUNE/SEL knob. The list of features will thenappear, and you can repeat Step 6.3-70
