7. Firmly press and release the “Learn” or “Smart”button. The name and color of the button mayvary by manufacturer.You will have 30 seconds to start Step 8.8. Return to the vehicle. Firmly press and hold theprogrammed HomeLink® button for two seconds,then release. Repeat the press/hold/releasesequence a second time, and depending on thebrand of the garage door opener (or other rollingcode device), repeat this sequence a third timeto complete the programming.HomeLink ® should now activate your rolling-codeequipped device.To program the remaining two HomeLink® buttons,begin with Step 2 of “Programming HomeLink® .” Do notrepeat Step 1.Gate Operator and CanadianProgrammingCanadian radio-frequency laws require transmittersignals to “time out” or quit after several seconds oftransmission. This may not be long enough forHomeLink® to pick up the signal during programming.Similarly, some U.S. gate operators are manufactured to“time out” in the same manner.If you live in Canada, or you are having difficultyprogramming a gate operator by using the“Programming HomeLink® ” procedures (regardless ofwhere you live), replace Step 3 under “ProgrammingHomeLink® ” with the following:Continue to press and hold the HomeLink® button whileyou press and release every two seconds (cycle)your hand-held transmitter until the frequency signal hasbeen successfully accepted by HomeLink® . Theindicator light will flash slowly at first and then rapidly.Proceed with Step 4 under “Programming HomeLink® ”to complete.2-43
