Easy Series Programming Access Options | en 35Bosch Security Systems, Inc. System Reference Guide F01U087835 | 02 | 2008.10Modem DialThe RPS operator uses a telephone connected in parallel to the RPS modem and clicks theConnect To button in the RPS Panel Communication Window to dial the premises phonenumber.1. Connect the internal modem on the RPS PC, or an external modem, to the control panel.2. When the control panel answers the incoming call, the system announces "Enter yourpasscode."3. When you hear the control panel modem tones, press the Connect To button on the RPSPanel Communication window. RPS then sends the DTMF tone to connect to the controlpanel.Direct ConnectSelect this method to establish a local, on-site connection between the RPS PC (or laptop)and the control panel.1. On the Telco side of the phone line, ensure that Tip and Ring are disconnected.2. Connect the internal modem on the RPS PC, or an external modem, to the control panel.Refer to Figure 4.1, Page 35.Figure 4.1 Modem Connections3. If the first communication attempt fails, connect a 270 Ω to 330 Ω, ¼ W resistor in serieswith the Tip House side. Refer to Figure 4.1, Page 35.NetworkSelect this method to establish a network connection between the RPS PC (or laptop) andthe control panel using the ITS-DX4020-G or the DX4020.1 Connection using internal modem2 Connection using external modem3 270 Ω to 330 Ω, ¼ W resistor (for Direct Connection option only)
