Menu
Bosch ICP-EZM2 Easy Series System Reference Manual
Also see for ICP-EZM2: Quick start guideInstaller's guideSystem reference guide
                                                                                                                              | |
Contents
|
24 en | System Installation and Configuration Easy SeriesF01U087835 | 02 | 2008.10 System Reference Guide Bosch Security Systems, Inc.Table 2.6 Wireless Device Test ProceduresAfter each successful point test, the system announces "Point xx was tested."If you test a point and the system only announces "Point xx," the point number is assigned,but has not been tested:– If you prefer specific point numbers, do not continue. Fix any issue with the device andre-test until the system announces "Point xx was tested."– If you do not prefer specific point numbers, you can test them later through the InstallerMenu. When the system completes the testing, the system announces "Wireless devicesnot configured."7. The system says, "System test complete.”2.7.5 Add Users, Tokens, and Key Fobs1. From the User Phone Menu (refer to Section 2.7.2 Initiate a Phone Session from the ControlPanel, page 22), press [4] to enter the User Menu.2. From the User Phone Menu, press [4] to enter the User Menu.3. Press [1] to add a new user. After you add a new user, you can also assign a token,passcode, and key fobs to that user.4. Repeat Step 4 to add more users.5. Press [#] to return to the User Menu.Water Sensor/Low-temperature SensorWater Sensor: Select one of the following methods:– Short the water probe pins for at least 5 sec.– Submerge the water probe in water for at least 5 sec.Low-temperature Sensor: Short the "T" pads for at least 5 sec.1 To test the inertia detector, create a shock to cause an inertia alarm, and then restore alarm.2 To test the glass break detector, use a special tool to cause a glass break alarm, and then restore the alarm.3 If you tamper the detector, the control panel enrolls the detector, but does not test it. You must create the appropriate alarm andrestore the alarm to test the detector.Device To Testi NOTICE!If you plan to use a programming key to copy control panel data for back up or use on anothersystem, back up the data now. Refer to Section 4.3 Programming Keys, page 36. |
Related manuals for Bosch ICP-EZM2
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved