Easy Series Table of Contents | en 3Bosch Security Systems, Inc. System Reference Guide F01U087835 | 02 | 2008.10Table of Contents1 Overview 61.1 Installation Workflow 61.2 System Components and Wiring 61.3 Phone Menus 101.3.1 Installer Phone Menu 101.3.2 User Phone Menu 112 System Installation and Configuration 122.1 Plan the Installation 122.2 Install System Components 132.2.1 Install the wLSN Hub 132.2.2 Install the Control Panel Enclosure 132.2.3 Install the Control Center 142.2.4 Route Power-limited Wiring 152.2.5 Install the ITS-DX4020-G Communicator and Antenna 152.2.6 Install the DX2010 Input Expander 162.2.7 Connect the Conettix DX4020 Network Interface Module 162.2.8 Connect Supervised Points 162.3 Apply System Power 172.4 Initial System Startup 182.5 Perform the RFSS Site Test using the wLSN Installation Tool 182.5.1 Prepare the wLSN Hub for Site Testing and RFSS Mode 192.5.2 wLSN Installation Tool Mode 1 192.5.3 wLSN Installation Tool Mode 2 202.5.4 wLSN Installation Tool Mode 3 212.6 Install wLSN Devices 222.7 Configure the System from the Installer Phone Menu 222.7.1 Upgrade the Control Panel (Optional) 222.7.2 Initiate a Phone Session from the Control Panel 222.7.3 Configure Required Control Panel Settings 222.7.4 Discover Wireless Devices 232.7.5 Add Users, Tokens, and Key Fobs 242.8 Configure the ITS-DX4020-G Communicator 252.8.1 Configure the Control Panel for Cellular Communication 252.8.2 Configure the ITS-DX4020-G 252.8.3 Test ITS-DX4020-G Communications 273 Point Expansion 283.1 Perform a RFSS Site Test with the Hub and the Device 283.2 Establishing the Wireless Network and Configuring Wireless Devices 283.2.1 Discover a New System 293.2.2 Establish and Configure the Wireless Network 293.2.3 Configure Devices 303.3 Wireless Maintenance 313.3.1 Wireless Configuration Menu 313.3.2 Assigning Points 1 to 8 as Wireless Points 32
