R5906151 /02 XDL444.1 Switching on the XDLAbout the start up processTo start up the XDL series projector the sealed compartment of the Light Processor and the sealedcompartment of the Laser Clusters must be brought into a 'condition' which is safe for the electronics tooperate (avoid moisture due to extreme cooling). In other words, the temperature and humidity inside thesecompartments must be brought within specs prior to activating the lasers and Light Processor. The timeneeded to bring the projector from a deconditioned state into a conditioned state depends on the ambientconditions and can take several minutes. This process is called conditioning.Keep in mind that it can take up to 10 minutes to start the lasers again after they were switched off.If there are only 30 to 45 minutes between the shows it’s advisable to keep the lasers on withshutter closed. When the shutter is closed the lasers are automatically dimmed.Start up procedure1. Switch on the chiller(s). The status light of the chiller(s) should light up white. See documentation set of thechiller.2. Press the Power Switch (reference 1, Image 4-1) to switch the projector ON.The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved(reference 1, Image 4-2). Once in standby mode, the Power on/off button will be lit WHITE, but the display willbe off.1Image 4-13. Press the Power on/off button on the projector, or the Power On button on the remote control. The projectorwill continue to operational mode. The Power on/off button will blink BLUE until the projector is ready(reference 2, Image 4-2). In this process the shutter will close and the Shutter button will be lit RED. The startup screen is displayed on the touch panel and when fully started up, it changes to the overview screen.Once the projector is ready & conditioned, the Power on/off button will be lit BLUE. Now the lasers are activeand light can come out of the projector. The shutter however remains closed. While the shutter is closed, thelasers will be set to minimum power.12Image 4-24. Press the SHUTTER button on the Local Keypad, remote control or use the Projector Toolset to open theshutter.Note: The state of the shutter (open or closed) when starting up the projector will be the same aswhen the projector was switched off. This procedure assumes that the shutter was closed .Getting Started
