R5906151 /02 XDL 101Image 8-658.8.5 3D emitter SetupWhy change the 3D setup?While Barco can provide a 3D emitter and active shutter glasses as options to this projector, you are also freeto use a 3D emitter and active shutter glasses of your own choice. Since glasses and emitter can have variousspecifications compared to the ones Barco can provide, the 3D setup menu allows you to configure the outputimage to the specifications of your glasses and emitter. The following can be configured:• Swap Eye: You can choose to invert the stereo Sync output signal ( depending on the chosen 3D emitterand glasses).• Swap frame pair: You can choose to invert the stereo input signal (depending on the chosen sourceinput).• Dark time: You can select how much dark time the projected image will have between frames. You canchoose one of the options between 1000 μs and 2500 μs.• Stereo glasses: You can select the desired type of 3D glasses. You can choose between Active 3Dglasses, or 6P Laser Glasses.• Sync Delay: You can increase or decrease the sync delay. The scale goes from –10 000 μs to +10 000 μswith a step of 100 μs.If a 3D emitter is used that radiates infrared beams (IR beams), the IR beams may interfere with theIR communication between projector and the RCU. If such interference occurs, connect the RCU tothe projector using the remote cable. It is also advised to turn the IR receivers on the projector off toavoid the 3D emitter interference. To turn off the IR receivers, see “Remote control, on/off button”,page 23.How to adjust the projector to the 3D emitter?1. In the main menu, select Installation → 3D Setup.Image 8-66: Installation menu, 3D setupThe 3D setup menu is displayedGUI – Installation
