R5906151 /02 XDL262.8 Using the XLR connector of the RCUConnecting a cable with the XLR connector will reset the broadcast address of the RCU to itsdefault value '0'.How to use the XLR connector1. Remove the XLR cover by pulling it backwards.Image 2-72. Connect a cable with XLR plug into the XLR connector of the RCU.3. Connect the other end of the cable with the XLR input of the projector.Note: While the XLR cable is connected, the IR beam of the RCU is switched off.2.9 Using the mini-jack connector of the RCUConnecting a cable with the mini-jack connector will reset the broadcast address of the RCU to itsdefault value '0'.How to use the mini-jack connector1. Connect a cable with the mini-jack connector (reference 2 Image 2-8) of the RCU.2. Connect the other end of the cable with the mini-jack input of the projector.2Image 2-8Note: While the mini-jack cable is connected, the IR beam of the RCU is switched off.Pulse Remote Control Unit
