R5906151 /02 XDL100Source Layout mode Video Timing /cableFixedconfiguration? Color depthActive Stereo(sequential L/R)Standard layout (1x1layout)2560 x 1600 @120Hz30 bppActive Stereo(sequential L/R)4 Column mode (4x1layout)960 x 2160 @120 Hz 30 bppActive Stereo(sequential L/R)4 Quadrant mode(2x2 layout)1920 x 1080 @120Hz30 bppPassive Stereo(separate L/R)Standard layout (1x1layout)3840 x 2160 @60 Hz • Cable 1: left eye• Cable 2: right eye30 bppPassive Stereo (dualpipe L/R)2 Column mode (2x1layout)1920 x 2160 @60 Hz • Cable 1: left eye,left column• Cable 2: left eye,right column• Cable 3: righteye, left column• Cable 4: righteye, right column30 bpp8.8.4 Choosing the desired Display SetupOutput modesThe following output modes are available:• AutoStereo: Automatic mode (2D input = 2D output, 3D input = Active Stereo output).• Mono: Forces all source signals to 2D output.• ActiveStereo: Forces all source signals to Active Stereoscopic 3D.Use the following table as an indicator of what display mode you require.Source signal AutoStereo Mono ActiveStereo2D Source Output is a 2D image Output is a 2D image Output is in Active StereoActive Stereo source Output is in Active Stereo Output is a 2D image Output is in Active StereoPassive Stereo source Output is in Active Stereo Output is a 2D image Output is in Active StereoWhen a different Display Mode is chosen compared to the source signal (e.g. Active Stereo sourcewith Mono output), advanced image processing will make sure you a desirable image will bedisplayed.How to select the desired projection method?1. In the main menu, select Installation → Display Setup.Image 8-64: Installation menu, Display setupThe Display setup menu is displayed.2. Select the desired Display Mode:• AutoStereo (default value)• Mono• ActiveSteroGUI – Installation
