R5906151 /02 XDL32You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you cancontrol the projector from that DMX device (console). The DMX output port can be connected with the nextdevice in the loop.Pin Description1 Earth2 Cold3 Hot4 Return - (or not used)5 Return + (or not used)DMXDMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from alighting controller to lighting devices. Standardized by USITT.RS232/RS422 inputThe communication interface of the XDL series projector supports RS232 and RS422 serial communication ontwo different types of input connectors, a Sub-D connector and an USB connector acting as RS input whenconnected to an USB input of a PC.You can use the RS232/RS422 input to connect a local PC to your XDL series projector. By this way you canconfigure and control your projector from your local PC.Advantages of using RS232/RS422 serial communication:• easy adjustment of the projector via PC (or MAC).• allow storage of multiple projector configurations and set ups.• wide range of control possibilities.• address range from 0 to 255.• sending data to the projector (update).• copying data from the projector (backup).RS232/422 input (Sub-D) portPin Description1 DCD : Data Carrier Detect2 RXD- : Receive Data3 TXD- : Transmitted Data4 DTR : Data Terminal Ready [RS232]TXD+ : Transmitted Data [RS422]5 GND : Ground6 DSR : Data Set Ready [RS232]RXD+ : Received Data [RS422]7 — (not connected) —8 CTS : Clear To Send9 RI : Ring IndicatorInput & Communication
