Asus DS300j G2 Series User Manual

Contents

DS300f G2 Series User Manual93makInG DISk array SettInGSTo make disk array settings:1. Click the Storage tab.2. Click the Disk Array icon.The list of disk arrays appears.3. Click the disk array you want, then click the Settings button.4. Make settings changes as required:• Enter, change or delete the alias in the Alias fieldMaximum of 32 characters; letters, numbers, space between characters, and underline.• Media Patrol – Check to enable, uncheck to disable on this array.• PDM – Check to enable, uncheck to disable on this array.• Power Management – Check to enable, uncheck to disable on this array.5. Click the Save button.NotesYou can also enable or disable Media Patrol for the entire RAID system. See Making MediaPatrol Settings.HDD Power Saving must be enabled on the RAID controller for the Power Managementsettings to be effective. See Making Controller Settings.Power Management functions are limited to the features your HDDs actually support.DeletInG a DISk arrayCautionIf you delete a disk array, you also delete any logical drives that belong to it, alongwith the data in those logical drives. Back up any important data before deleting adisk array.This action requires Administrator or Super User privileges.To delete a disk array:1. Click the Storage tab.2. Click the Disk Array icon.3. Click the disk array you want, then click the Delete button.4. In the Confirmation box, type the word “confirm” in the field provided and click the Confirm button.locatInG a DISk arrayThis feature causes the drive carrier LEDs to flash for one minute to assist you in locating the physical drivesthat make up this disk array.To locate a disk array:1. Click the Storage tab.2. Click the Disk Array icon.The list of disk arrays appears.3. Click the disk array you want, then click the Locate button.The drive carrier status LEDs for the array flash for one minute.Figure 4 - 6: Drive carrier status LEDDrive Status LED