Asus DS300j G2 Series User Manual

Contents

DS300f G2 Series User Manual153• Highlight Ping Through Controller ID and choose a controller (1 or 2)• Highlight Ping Through Port ID and choose a port number (1 to 4)To change a value, highlight the item, press Backspace to delete the current value and type a new value.4. Highlight Ping and press Enter.The results of the ping are displayed on the iSCSI Ping screen.vIewInG a lISt of IScSI trunkS (clu)A trunk is the aggregation of two or more iSCSI ports to increase bandwidth.To view a list of iSCSI trunks:1. From the Main Menu, highlight iSCSI Management and press Enter.2. Highlight Trunk and press Enter.The list of iSCSI Trunks displays.• ID – ID number of the trunk. Starts at 1.• CtrlId – RAID controller ID, 1 or 2• Master Port – One of the four physical ports on the RAID controller• Slave Ports – Any or all of the remaining physical ports on the same RAID controller• Failed Ports – A slave port that has no iSCSI data connection.• State – Optimal, Sub-Optimal or Failed. Identify and correct the failed iSCSI ports.aDDInG IScSI trunkS (clu)Ports must be enabled to add them to a trunk. See "Making iSCSI Port Settings (CLU)" on page 148. ASUSDS300f G2 supports a maximum of eight trunks.You cannot use an iSCSI port that has portals configured to it. See "Viewing a List of iSCSI Portals (CLU)" onpage 148 and "Deleting iSCSI Portals (CLU)" on page 150.To add an iSCSI Trunk:1. From the Main Menu, highlight iSCSI Management and press Enter.2. Highlight Trunk and press Enter.3. Highlight Create New Trunk and press Enter.4. Enter information as required:• Highlight Controller and type the controller you want (1 or 2).• Highlight Master Port and type the port number you want (1 to 4).• Highlight Slave Ports and type the port number you want.For multiple ports, separate the numbers with a comma.You can choose any or all port numbers except the Master Port number.5. Highlight Save Trunk and press Enter.The new trunk appears in the list.You can add up to 8 trunks. After you add a trunk, you can assign it to a portal. See"Adding iSCSI Portals(CLU)" on page 149.makInG IScSI trunk SettInGS (clu)To make trunk settings:1. From the Main Menu, highlight iSCSI Management and press Enter.2. Highlight Trunk and press Enter.3. Highlight the trunk you want and press Enter.4. Enter information as required:• Highlight Controller and type the controller you want (1 or 2).• Highlight Master Port and type the port number you want (1 to 4).• Highlight Slave Ports and type the port number you want.For multiple ports, separate the numbers with a comma.You can choose any or all port numbers except the Master Port number.5. Highlight Save Settings and press Enter.DeletInG IScSI trunkS (clu)Before you can delete a trunk, you must delete any portals configured on it. See "Deleting iSCSI Portals (CLU)"on page 150.To delete an iSCSI trunk:1. From the Main Menu, highlight iSCSI Management and press Enter.2. Highlight Trunk and press Enter.3. Highlight the trunk you want to delete and press the Spacebar to mark it.4. Highlight Delete Marked Trunks and press Enter.5. Press Y to confirm.