set port type ap 95See Also set ip snmp server on page 173 set snmp community on page 179set port type ap Configures an WX switch port for a MAP access point.CAUTION: When you set the port type for MAP use, you must specifythe PoE state (enable or disable) of the port. Use the WX switch’s PoE topower 3Com MAP access points only. If you enable PoE on a portconnected to another device, physical damage to the device can result.Before configuring a port as a MAP access point port, you must use theset system countrycode command to set the IEEE 802.11country-specific regulations on the WX switch. See “set systemcountrycode” on page 58.For a MAP that is indirectly connected to the WX switch through anintermediate Layer 2 or Layer 3 network, use the set dap command toconfigure a Distributed MAP.Before changing the port type from ap to wired-auth or fromwired-auth to ap, you must reset the port with the clear port typecommand.Syntax — set port type ap port-list model {ap2750 | ap3750|ap7250 | ap8250 | ap8750 | mp-52 | mp-241 | mp-252 | mp-262 |mp-341 | mp-352 | mp-372 | mp-372-CN | mp-37-JP | mp-620}poe {enable | disable}[radiotype {11a | 11b | 11g}] port-list — List of physical ports. model {ap2750 | ap3750| ap7250 | ap8250 | ap8750 | mp-52 |mp-241 | mp-252 | mp-262 | mp-341 | mp-352 | mp-372 |mp-372-CN | mp-37-JP | mp-620} — MAP access point model: poe enable | disable — Power over Ethernet (PoE) state. radiotype 11a | 11b | 11g — Radio type: 11a — 802.11a 11b — 802.11b 11g — 802.11g
