load config 627Table 107 describes the fields in the display version output.See Also display boot on page 622load config Loads configuration commands from a file and replaces the WX switch’srunning configuration with the commands in the loaded file.CAUTION: This command completely removes the running configurationand replaces it with the configuration contained in the file. 3Comrecommends that you save a copy of the current running configuration toa backup configuration file before loading a new configuration.Syntax — load config [url] url — Filename. Specify between 1 and 128 alphanumeric characters,with no spaces.If the file is in a subdirectory, specify the subdirectory name, followedby a forward slash, in front of the filename. For example:backup_configs/config_c.Table 107 Output for display versionField DescriptionBuild Information Factory timestamp of the image file.Label Software version and build date.Build Suffix Build suffix.Model Build model.Hardware Version information for the WX switch’s motherboard andPower over Ethernet (PoE) board.Serial number Serial number of the WX switch.Flash Flash memory version.Kernel Kernel version.BootLoader Boot code version.Port/DAP Port number connected to a MAP access point.AP Model MAP model number.Serial # MAP serial number.Versions MAP hardware, firmware, and software versions.
