set rfdetect attack-list 601set rfdetectattack-listAdds an entry to the attack list. The attack list specifies the MACaddresses of devices that MSS should issue countermeasures againstwhenever the devices are detected on the network. The attack list cancontain the MAC addresses of APs and clients.Syntax — set rfdetect attack-list mac-addr mac-addr — MAC address you want to attack.Defaults — The attack list is empty by default.Access — Enabled.History —Introduced in MSS Version 4.0.Usage — The attack list applies only to the WX switch on which the list isconfigured. WX switches do not share attack lists.When on-demand countermeasures are enabled (with the setradio-profile countermeasures configured command) only thosedevices configured in the attack list are subject to countermeasures. Inthis case, devices found to be rogues by other means, such as policyviolations or by determining that the device is providing connectivity tothe wired network, are not attacked.Examples — The following command adds MAC addressaa:bb:cc:44:55:66 to the attack list:WX4400# set rfdetect attack-list 11:22:33:44:55:66success: MAC 11:22:33:44:55:66 is now in attacklist.See Also clear rfdetect attack-list on page 580 display rfdetect attack-list on page 583 set radio-profile countermeasures on page 374
