Installation ManualH3C S7500 Series Ethernet Switches Chapter 7 Software Maintenance7-14downloading is completed, the remaining procedure is the same as that in the case ofloading using FTP.7.4 Loading Boot ROM and Host Software to the S7506RThe H3C S7506R is equipped with two SRPUs. Slots 0 and 1 are for SRPUs and therest slots are for LPUs. Thus, loading Boot ROM and host software to the S7506Rinvolves loading Boot ROM and host software to the active and standby SRPUs, andloading Boot ROM to LPUs.The following two loading approaches are available on the S7506R:z Loading through command linesz Loading through the BOOT menuHowever, you can load a Boot ROM to LPUs only through command lines.When loading a Boot ROM or host software, note that:z To keep consistent the software versions of the active SRPU, standby SRPU, andLPUs, use the same approach (either command lines or BOOT menu) to load theBoot ROM or host software to the active and standby SRPUs.z If the current Boot ROM matches the host software to be loaded, you do not needto load the Boot ROM to the active SRPU, standby SRPU, and LPUs.Note:Loading through command lines affects switch services less significantly than loadingthrough the BOOT menu. You are recommended to load a Boot ROM or host softwarethrough command lines.7.4.1 Loading Through Command LinesAssume that:z The target Boot ROM is BTM530.btm.z The primary boot file is S7506R002.app and the host software running on theswitch is S7506R001.app.z The active SRPU is inserted in slot 0, the standby SRPU in slot 1, and an LPU inslot 3.I. Loading using FTPRun the FTP Server on the local computer. Check whether a username, a password,and the correct file directory have been configured. Log in to the switch through Telnetor through the console port and transfer host software to the switch using FTP.
