Installation ManualH3C S7500 Series Ethernet Switches Chapter 7 Software Maintenance7-2Note:You can follow the same procedure to load a Boot ROM and host software, except thatin a Boot ROM loading process you need to press Ctrl + U and Enter and will viewdifferent prompt information after entering the Boot menu. All loading proceduresdescribed in this chapter focus on how to load a Boot ROM.7.2.1 BOOT MenuUpon power-on, the switch will run the Boot ROM program and the terminal will displaythe following information:******************************************* ** H3C S7506 BOOTROM, Version 530 ** *******************************************Copyright(c) 2004-2007 Hangzhou H3C Tech. Co., Ltd.Creation date : Apr 20 2007, 20:08:58CPU type : MPC8245CPU Clock Speed : 300MhzBUS Clock Speed : 33MhzBOOT_FLASH type : M29W040BFlash Size : 32MBMemory Size : 256MBS7506 main board self testing................................SDRAM Data lines Selftest.................................OK!SDRAM Address lines Selftest..............................OK!SDRAM fast selftest.......................................OK!Please check LEDs.....................LEDs selftest finished!CPLD selftest.............................................OK!FPGA selftest.............................................OK!The switch Mac address is .....................0000.0309.0004Note:The above information may vary slightly with the models of the S7500 series.Press Ctrl+B to enter Boot Menu... 5
