1-5undo mirroring-group group-id monitor-port monitor-portViewSystem view, Ethernet port viewParametersgroup-id: Number of a port mirroring group, in the range 1 to 20.monitor-port monitor-port: Specifies the destination port for port mirroring. monitor-port isavailable in system view only, and there is no such argument in Ethernet port view.DescriptionUse the mirroring-group monitor-port command to configure the destination port for alocal mirroring group or a remote destination mirroring group.Use the undo mirroring-group monitor-port to remove the destination port of a localmirroring group or a remote destination mirroring group.Note that:z You cannot configure a member port of an existing mirroring group, a member port ofan aggregation group, a fabric port or a port enabled with LACP or STP as thedestination port.z Before configuring a destination port for a local mirroring group, make sure that thecorresponding mirroring group has already been created.z It is recommended that you use a destination port for port mirroring purpose only. Donot use a destination port to transmit other service packets.Related commands: display mirroring-group.Examples# Configure Ethernet 1/0/4 as the destination port of local mirroring group 1. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] mirroring-group 1 local[Sysname] mirroring-group 1 monitor-port Ethernet 1/0/4mirroring-group reflector-portSyntaxmirroring-group group-id reflector-port reflector-portundo mirroring-group group-id reflector-port reflector-portViewSystem view, Ethernet port view
