1-11-3 192.168.3.1Incoming Interface Address: 192.168.4.2Previous-Hop Router Address: 0.0.0.0Input packet count on incoming interface: 0Output packet count on outgoing interface: 0Total number of packets for this source-group pair: 0Protocol: PIMForwarding TTL: 0Forwarding Code: No errorTable 1-6 mtracert command output descriptionField DescriptionFrom last-hop router(192.168.2.2), tracereverse path to source 192.168.4.1 via RPFrulesReverse path from the last-hop router(192.168.2.2) to the multicast source(192.168.4.1)-1 5.5.5.8 Outgoing interface address of each hop, startingfrom the last-hop routerIncoming interface address Address of the interface on which (S, G) packetsarrivePrevious-hop router addressIP address of the router from which this localdevice receives multicast packets sent by thesourceInput packet count on incoming interface Total number of multicast packets received onthe incoming interfaceOutput packet count on outgoing interface Total number of multicast packets transmitted onthe outgoing interfaceTotal number of packets for this source-grouppairTotal number of packets from the specifiedsource forwarded by this device to the specifiedgroupProtocol The multicast routing protocol in useForwarding TTLThe minimum TTL that a packet is required tohave before it can be forwarded over theoutgoing interfacemulticast route-limitSyntaxmulticast route-limit limitundo multicast route-limitViewSystem viewParameterslimit: Maximum number of multicast routing table entries, in the range of 0 to 256.