GDC PSD-3000-P manuals

PSD-3000-P

Brand: GDC | Category: Computer Hardware

Table of contents

1. Table Of Contents
2. Table Of Contents
3. Table Of Contents
4. INTRODUCTION
5. Equipment List
6. INSTALLING SX-3000 INTO THE PROJECTOR
7. Remove existing interface board/placeholders from projector
8. Christie Projector Placement
9. Inserting SX-3000 into the projector
10. INSTALLING PSD-3000-P PORTABLE STORAGE DEVICE
11. Front Panel
12. Installing the Bracket on a Barco S2K projector
13. Installing the Bracket on a NEC S2K projector
14. Installing the Bracket on a Barco B or C Series projector
15. Installing the Bracket on a NEC 2K or 4K projector
16. Installing the Bracket on a Christie CP2220 or CP2230 projector
17. eSATA Connection to the SX-3000
18. Procedure to Install the HDDs
19. PSD-3000-P Indicator
20. Warning Buzzer
21. OPERATION OF PSD-3000-P
22. Hard Disk Information
23. Increase Rebuild Speed
24. IMB Network Setup
25. Projector Connection
26. Barco Series 2 Projector Setup
27. Barco Touch Panel Setup
28. NEC Series 2 Projector
29. Christie Series 2 Projector
30. D settings for Series 2 projectors
31. IMB 3D macro settings changes
32. Time Zone Setup
33. Content Ingest Management Setup
34. Content ingest from FTP
35. Audio Setup
36. Digital-to-Analog Converters
37. AUTOMATION SETUP
38. Adding event labels and actions
39. Automation Scheduling
40. Automation setup for server GPIO
41. Automation setup for eCNA devices
42. Automation setup for JNIOR devices
43. Automation setup for Christie ACT devices
44. Automation setup for Dolby devices
45. Automation setup for USL DAX devices
46. Automation setup for USL JSD devices
47. SETUP
48. AES Audio and GPIO Pinout