347.1.1. Barco Touch Panel SetupThe Barco Projector touch panel can be used to control the SX-3000. Use the following steps toset up control of the SX-3000 from the Barco touch panel.1. On the Barco touch panel, select [Control] [Server]. The new window [ConnectionProperties] will appear as shown in Figure 39.Figure 39 Barco touch panel settings [Connection Properties].2. Enter the SOM IP address of the SX-3000 into the “Host Name” field. The remainingfields should be filled in as follows (please refer to Figure 40):Display or port: 5900Check the [Use as port] checkboxPassword: gdcvncFigure 40 Barco touch panel settings [VNC Viewer Connection].3. Click the [Connect now] button, the SMS user interface will be shown on the Barcotouch panel.
