285.2. Hard Disk InformationThe PSD-3000-P is seen by the SX-3000 as a hardware RAID. When the hard disk informationcheck is done the RAID set will show as one drive, like below:Figure 31 Hard disk information [Storage System Management].5.3. RAID StatusWhen the RAID is rebuilding, the [Monitor RAID Status] section displays the rebuilding progressas normal function to the previous RAID setup.5.4. Creating a new RAID ArrayWhen creating a new RAID array the option to select the drives seen in previous systems is nolonger needed. After selecting [Create New RAID Array] a confirmation page will pop up toconfirm the decision.The new RAID creation will take just 1-2 minutes.
