7.6 Initializing Parameter Settings (Fn005)7-117 Utility Functions (Fn)7.6 Initializing Parameter Settings (Fn005)This function is used when returning to the factory settings after changing parameter settings.Follow the steps below to initialize the parameter setting.• Be sure to initialize the parameter settings with the servo OFF.• After initialization, turn OFF the power supply and then turn ON again to validate thesettings.Step Display afterOperation Keys Operation1 Press the MODE/SET Key to select the utility functionmode.2 Press the UP or DOWN Key to select Fn005.3 Press the DATA/SHIFT Key for approximately one second.The display shown on the left appears.4Display blinksPress the MODE/SET Key. Then, the parameters will beinitialized.During initialization, the display shown on the left blinks.5Display blinksWhen the initialization of parameter setting completes, thedisplay shown on the left blinks for about one second.6 The display changes from "donE" to the display shown onthe left.7 Press the DATA/SHIFT Key for approximately one second."Fn005" is displayed again.8 Turn OFF the power and then turn ON again to validate the setting.MODE /SET DATA/MODE/SET DATA/MODE/SET DATA/MODE /SET DATA/MODE/SET DATA/
