7 Utility Functions (Fn)7-10(6) Operating ProcedureFollow the steps below to perform the program JOG operation.Step Display afterOperation Keys Operation1 Press the MODE/SET Key to select the utility function mode.2 Press the UP or DOWN Key to select Fn004.3 Press the DATA/SHIFT Key for more than one second. The dis-play shown on the left appears.4 Press the MODE/SET Key. The servo turns ON.5Press the UP or DOWN Key according to the first movementdirection of the operation pattern. After the preset waiting time,the movement starts.Notes:• Press the MODE/SET Key again during operation, and the ser-vomotor will be in baseblock status and stop.• Press the DATA/SHIFT Key for more than one second duringoperation, the servomotor stops and the display of step 2appears.6（Blinking）"End" blinks when the program JOG operation movement com-pletes, and the display of step 4 appears.Notes:• Press the MODE/SET Key, and the servomotor will be in base-block status and the display of step 3 appears.• Press the DATA/ENTER Key for more than one second, andthe display of step 2 appears.MODE /SET DATA/MODE/SET DATA/MODE/SET DATA/MODE /SET DATA/MODE/SET DATA/
