Administrator Tools PasswordWorkCentre™ 5735/5740/5745/5755/5765/5775/5790System Administrator Guide522. In the Settings area:a. Select [FTP] from the [Protocol] drop-down menu.Note: Only FTP is available.b. Select either the [IP Address], [IPv4 Address] or [Host Name] radio button for your FTPserver.c. Enter details of the repository server in the [IP Address: Port] or [Host Name: Port] field.d. For [Document Path], specify the path to the file repository.e. For [File Name], type the file name for the backup to restore. This name will be appended tothe document path.f. For [Login Name], if you selected System for Login Credentials (referring to FTP repository inthe Workflow Scanning topic), then you must specify the system login name here.g. For [Password] and [Retype Password], if you selected System for the login credentials, thenyou can specify and confirm the system password here. The password may be blank.h. Check the [Select to save new password] checkbox for an existing Login Name.3. Click on the [Start] button at the bottom of the page to implement the password change, or[Undo] to cancel any changes.Online/OfflineThe Online/Offline window allows the System Administrator to stop and resume the system fromreceiving or sending jobs over the network.At the Device:Note: To configure this feature or these settings access the Tools pathway as a SystemAdministrator. For details, refer to Access Tools Pathway as a System Administrator on page 18.1. From the Tools pathway, touch [Network Settings].2. Touch [Online/Offline].3. To stop the device receiving or sending jobs over the network touch [Offline]. Any installedoptional features using the network (for example Workflow Scanning) will not be available untilthe device is set to Online.Note: To enable the device to receive or send jobs over the network touch the [Online] button.4. Touch [Save].5. Press the button.6. Touch [Logout] to exit the Tools pathway.Foreign Interface DeviceA third party access and accounting device, such as a coin operated device or a card reader can beattached to the device. To enable this option, the Foreign Device Interface Kit must be installed. After
