CONTROLLER SPECIFICATIONS AND REQUIREMENTSXEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE 5-9Printer controller hardware specifications and requirements summaryThe following table summarizes the specifications and electricalrequirements of your DocuPrint IPS printer controller hardwarecomponents.For a summary of printer hardware specifications and requirements,refer to the “Printer specifications and requirements” chapter of thisguide. Contact your service representative if you have questions notspecifically addressed in this guide.Table 5-3.96/4635/180 IPS printer controller specifications andpower requirementsDeviceDimensions (depth,width, height) WeightHeatdissipation Power requirements Cable lengthsHost ChannelUnit (HCU)(channel-attachedsystems only)d=15 in. / 40.8 cmh=5 in. / 12.6 cmw= 16 in. / 41.6 cm26 lbs. 10oz. / 12.4kgsN/A 120 VAC within 6 feet;120 volt at 2 amps or240 volt at 1 ampBus and tagcables mustconform to hostsystemrequirements(200 to 400 ft. /66.7 to 133.3 m)andaccommodatesystem setup.Processor d=16.1 in. / 40.9 cmw=16.4 in. / 41.7 cmh= 3 in. / 7.6 cm27 lbs. /12.7 kgs1,100 Btuper hoursSun Ultra 2 (60 Hz):100 to 240 VAC,15 amp, 0.4 KVA,5-15R NEMASun Ultra 2 (50 Hz):100 to 240 VAC,15 amp, 0.4 KVASun Ultra 60 (60 Hz):100 to 240 VAC,15 amp, 0.4 KVA,5-15R NEMASun Ultra 60 (50 Hz):100 to 240 VAC,15 amp, 0.4 KVAPower: 8 ft. /2.1 mInterface toprinter:20 ft. / 6.1 musable lengthMonitor d=6.1 in. / 41cmw=18.1 in. / 46 cmh=17.7 in. / 45 cm61 lbs. /27.7 kg408 Btuper hour100-120 ~ VAC,1 phase, 50-60 Hz,3.0 amp, 0.4 KVA200-240 ~ VAC,1 phase, 50-60 Hz,2.0 amp, 0.4 KVAVideo cable toprocessor:46 in. / 1.17 mPower: 8 ft. /2.4 m4 mm cartridgetape drived=12.2 in. / 31 cmw=7.5 in. / 19 cmh=2.8 in. / 7 cm8 lbs. /6.6 kg--- 100-120/200-240 VAC,0.8/0.4 amp, 47-63 HzSCSI cable toprocessor oradditional SCSIdevice:28 in. / 71 cm
