DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENTXEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE E-29Configuration steps – OS/2This section describes the process for configuring a TCP/IP attachedhost computer with OS/2 to print on an IPDS printer such as your IPS.Configuration worksheet The following worksheet will help you in planning the IPS installation.It describes the key values which you need to supply when planningthe OS/2 configuration. All values on this worksheet must bedetermined before you begin the printer configuration on the host.1. Configure the printer for TCP/IP in OS/2Configure your IPS for TCP/IP. (Refer to your IPS Guide toConfiguring and Managing the System, chapter 4, “Setting up thePrinter Controller.”2. Provide TCP/IP routing information, if necessaryTCP/IP routing information is needed for remote LAN configurationsonly. (Refer to your host computer documentation for procedures, ifneeded.)Table E-23.OS/2 configuration worksheet for IPSItem description Also known as... Source Your valueDevice Name PSF/2 Control Panel—Define DeviceDevice Description PSF/2 Control Panel—Define DeviceDevice Resolution DPI, Pels per inch PSF/2 Control Panel—Define DeviceAttachment Type Printer Protocol PSF/2 Control Panel—Define Device TCP/IPIP Address TCP/IP AddressIPADDRXerox NPS Printer software installation.PSF/2 Control Panel—Attachment TypeSettingsTCP/IP Port Number PORTNO IPS configuration Interface window andsubwindowsPSF/2 Control Panel—Attachment TypeSettingsConnect Timeout Device Busy Time PSF/2 Control Panel—Define DeviceMax Transmission Unit MTUMax packet sizeMAXMTUOS/2 TCP/IP Configuration (TCPIPCFG)Xerox NPS printer installationQueue Name PSF/2 Control Panel—Define QueueQueue Description OS/2 PrinterQueue NamePSF/2 Control Panel—Define DeviceDevice Busy Time(Optional)Connect time-out PSF/2 Control Panel—Printer Definition
