Xerox DocuPrint 180 IPS Installation Planning Manual

Also see for DocuPrint 180 IPS Series: Message guide User guide Installation planning guide Reference guide Troubleshooting guide

Contents

Xerox DocuPrint 180 IPS Installation Planning Manual Manual pdf 50 page image

CONTROLLER SPECIFICATIONS AND REQUIREMENTS5-2 XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDEOutlet configurationsThis section discusses specifications for system outlets and therequired wall outlet configurations for the USA / Canada andinternationally.Note: All power outlets must be dedicated to this equipment. Whendetermining the electrical connections for your printing system, makesure that:• Each power cord has a separate circuit.• The printer power cord configurations match your receptacle.• Your electrical outlets are within the required specifications.50 Hz systems: Ensure that power connections are per local codes/regulations.The following figure shows a 60 Hz American and Canadian walloutlet in which to plug the printer controller and HCU.Figure 5-1. 60 Hz wall outlet1 AC Hot (ACH)2 AC Hot (ACH)3 Earth Ground (GND)The required American and Canadian wall outlet voltage is 100 to120 VAC between AC hot and neutral, and between AC hot and GND.The voltage is less than three VAC between GND and neutral.Refer to the 60 Hz and 50 Hz controller electrical requirements tablesearlier in this chapter for a description of the power specifications forthe controller.! Warning: To reduce the risk of electrical shock, do not plugcomponents into any other type of power system. Contract yourfacilities manager or a qualified electrician if you are not sure whattype of power is supplied to your work area.1 23