Xerox 8830 User Manual

Also see for Synergix 8825: User guide Setup guide User guide Release note System introduction

Contents

Xerox 8830 User Manual Manual pdf 14 page image

8825/8830 DDS User Guide/6Getting to know the 8825/8830 DDSThe ScannerDDS User Interface (continued)Option keys and Feature keysThe left half of the DDS User Interface contains the keys for selection ofoptions and is divided into three areas: Media Selection, Image Quality,and Reduction & Enlargement. Status Indicator Lamps illuminate to showwhich selections have been made.The Features keys are found to the right of the Display. Features areenabled by pressing the corresponding feature key. If the feature has anassociated screen, then that screen will be displayed when the key ispressed. If any features are then changed from the default state, thecorresponding status lamp is illuminated next to the key.Pressing the C/CA key on the numeric keypad twice returns all features tothe default state, and the corresponding status lamp is extinguished.If there is no associated screen for a feature, then pressing that feature keyeither alternately switches the feature on or off, or selects one of a list ofpossible options. When a feature is enabled, the corresponding status lampis illuminated.If the BEEP function is enabled (factory default), a beep sound will be heardwhen a key is pressed. If an improper key is pressed, a multiple beep soundwill be heard.Media SelectionThe Source button selects the source of the media on which the image willbe printed. Sheet tells the Printer to print from a manually inserted sheet ofmedia. R3 (8830 Printers only), R2, and R1 select the media stored onRoll 3 , Roll 2 and Roll 1 in the Printer. Auto automatically selects the rollcontaining the media that best fits the size of the captured image. For mostdocuments, the Scanner is able to automatically detect the width of thescanned document, permitting the Auto function to then automatically selectthe most appropriate roll of media.Note: Roll 2 and sheet feed are optional on the 8825 DDS. If these optionsare not installed, they cannot be selected. To print from a cut sheet, Sheetmode must be explicitly selected. The Auto mode cannot select a cut sheet.The Type button selects the kind of media on which to print: Bond, Vellum(tracing paper), or Film.Note: only media types actually loaded into the Printer can be selected.When a roll is selected, the media type for that roll is automatically selectedalso. Refer to the 8830 Printer Operator Manual for instructions about howto load rolls and specify the width and media