8825/8830 DDS User Guide/77ReferenceSystem Administration (continued)Security settingsNormally, the user may recall from memory the last image scanned and allthe settings associated with that image. The recalled image may then beprinted without the need to scan from the original document. Securityconcerns at certain installations may require that this feature be disabled.The SECURITY SETTINGS screen allows the operator to disable or enablethe image recall feature.The default setting is ENABLED.Press the Next key or the Previous key until the desired choice, ENABLEDor DISABLED, is shown. Then press the Enter key to confirm the choice.Press the Exit key to leave the SECURITY SETTINGS screen.Change PasswordOnce a valid password has been entered and accepted, the user may selectCHANGE PASSWORD to select a new password.The user is asked to enter the existing password. If the correct password isentered, the user may enter the new password, press the Enter key, enterthe new password a second time, and press the Enter key again. The newpassword is then in force, and the old password is no longer valid.Press the Exit key to leave the CHANGE PASSWORD screen.Note: the valid range for passwords is 0−65535.SECURITY SETTINGSIMAGE RECALL:ENABLEDCHANGE PASSWORDENTER OLD PASSWORD: *****
