UBI EasyCoder 501 – Service Manual211APPENDIX 1, cont'd.EasyCoder 501 E & SASetup Mode Overview, Part 14800240012006003003840019200UART3UART2SETUP:CONTRASTmin CONTRAST maxSETUP:SER-COMSER-COM:UART1SER-COM:BAUDRATEBAUDRATE:9600SPACEMARKODDEVENSER-COM:PARITYPARITY:NONE8SER-COM:CHAR LENGTHCHAR LENGTH:71SER-COM:STOP BITSSTOP BITS:2SER-COM:FLOWCONTROLFLOWCONTROL:RTS/CTSENABLERTS/CTS:DISABLEFLOWCONTROL:ENQ/ACKENABLEENQ/ACK:DISABLEFLOWCONTROL:XON/XOFFXON/XOFF:DATA FROM HOSTDISABLEDATA FROM HOST:ENABLEXON/XOFF:DATA TO HOSTDISABLEDATA TO HOST:ENABLEFLOWCONTROL:PROT ADDRENABLEPROT ADDR:DISABLECRLFSER-COM:NEW LINENEW LINE:CR/LFSETUP:DETECTIONDETECTION:LSS ADJUSTLABEL <> GAPDETECTION:FEEDADJFEEDADJ:STARTADJSTARTADJ:[0]:FEEDADJ:STOPADJSTOPADJ:[0]:SETUP:SERVICEEnterEnterIf an optional interface boardwith at least one serial channelis fitted, communication setupmenus for each of the channelswill be displayed.• Press F4/<– key to decrease 1 step• Press F5/–> key to increase 1 stepBaudrate 38,400 is onlyavailable on "uart2:" and "uart3:"Not for RS422/485on "uart2:"Only for RS422/485on "uart2:"• Press F1/Ins key to view current value• Press F2/Del key to decrease value 1 step• Press F3/Esc key to increase value 1 step• Press F4/<– key to decrease value 10 steps• Press F5/–> key to increase value 10 steps• Press Feed key to autoadjust the LSS and feed out 1 label.• Press Enter to enter the Service part (see next page).• Press F5/–> to go back to the “Setup; Contrast” menu.• Press Setup/Save to exit the Setup Mode.LEGEND:Boxes with thick lines indicate default setupBoxes with dotted lines indicate menus related tooptional interface boards.
