© December 2005 TOSHIBA TEC e-STUDIO163/203 TROUBLESHOOTING5 - 435(14) Be sure to perform "05-310" with the platen cover or the ADF closed after replacing the SRAMboard.(15) Turn the power OFF and then start with the setting mode (08).(16) Set the setting value.Set the setting values of the following codes according to the list printed out in advance.(If the adjustment values could not be printed out because of the SRAM board damage or anyother reason, enter the values on the list output at the last maintenance. If there is no list, enterthe default values.)08-252 (Current value of PM counter Display)08-1150_0 (Photoconductive drum (Present number of output pages))08-1150_3 (Photoconductive drum (Present driving counts))08-1150_6 (Photoconductive drum (Present output pages for control))08-1150_7 (Photoconductive drum (Present driving counts for control))08-1200_0 (Developer material (Present number of output pages))08-1200_3 (Developer material (Present driving counts))08-1200_6 (Developer material (Present output pages for control))08-1200_7 (Developer material (Present driving counts for control))Also, set the setting values which have been changed for servicing.(17) Check that the setting value for 08-203 (Line adjustment mode) is "0" (For factory shipment). If itis “1” (For line), change it to “0”.06/05
