Toshiba e-STUDIO163 Service Handbook

Also see for e-STUDIO163: Specifications Operator's manual Service handbook Service handbook Service handbook

Contents

e-STUDIO163/203 TROUBLESHOOTING © December 2005 TOSHIBA TEC5 - 42(11) While pressing [0] and [2] simultaneously, turn the power ON. Enter the code for the destinationand press the [INTERRUPT] button.(Destination code: NAD: 1, CND: 86, JPD: 81, Other destinations: 44)* After pressing the [INTERRUPT] button, wait until the equipment goes into the ready statusas it starts in the normal mode automatically.(12) Turn the power OFF and then start with the adjustment mode (05).(13) Set the adjustment value.Set the adjustment values of the following codes according to the list printed out in advance.(If the adjustment values could not be printed out because of the SRAM board damage or anyother reason, enter the values on the list output at the last maintenance. If there is no list, enterthe default values.)05-201 (Correction of auto-toner sensor)05-205 (Developer bias DC output adjustment)05-210 (Main charger grid bias output adjustment)05-220 (Transfer transformer DC output adjustment (H))05-221 (Transfer transformer DC output adjustment (C))05-222 (Transfer transformer DC output adjustment (L))05-233 (Separation transformer DC output adjustment (H))05-234 (Separation transformer DC output adjustment (C))05-235 (Separation transformer DC output adjustment (L))05-305 (Image location adjustment of secondary scanning direction (scanner section))05-306 (Image location adjustment of primary scanning direction (scanner section))05-340 (Reproduction ratio adjustment of secondary scanning direction (scanner section))05-401 (Adjustment of primary scanning direction reproduction ratio (printer))05-405 (Adjustment of primary scanning direction reproduction ratio (copy))05-410 (Adjustment of primary scanning laser writing start position (copy))05-411 (Adjustment of primary scanning laser writing start position (printer))05-421 (Adjustment of secondary scanning direction reproduction ratio)05-440 (Adjustment of secondary scanning laser writing start position (drawer))05-442 (Adjustment of secondary scanning laser writing start position (bypass tray))05-430 (Top margin adjustment (blank area at the leading edge of the paper))05-431 (Left margin adjustment (blank area at the left of the paper along the paper feedingdirection))05-432 (Right margin adjustment (blank area at the right of the paper along the paper feedingdirection))05-433 (Bottom margin adjustment (blank area at the trailing edge of the paper))05-501 (Density adjustment Fine adjustment of "manual density"/Center value (Photo))05-503 (Density adjustment Fine adjustment of "manual density"/Center value (Text/Photo))05-504 (Density adjustment Fine adjustment of "manual density"/Center value (Text))05-512 (Density adjustment Fine adjustment of "automatic density" (Photo))05-514 (Density adjustment Fine adjustment of "automatic density" (Text/Photo))05-515 (Density adjustment Fine adjustment of "automatic density" (Text))Also, set the adjustment values which have been changed for servicing.06/05