83Starting a Conference by Calling a Remote PartyRedial functionOnce you have input the IP address or ISDN line number using the Detail Dialmenu, it will be entered in the text box of the Detail Dial menu the next timeyou open the menu.The redial function is not available:• Once you have turned off the power of the system or set it to standby mode.• When you cancel dialing the entered IP address or ISDN telephone number.• When you open the Detail Dial menu by pressing the number buttons on the RemoteCommander.To call a remote party with the Direct Phone Book button in launcher menu1 Use the V, v, B or b button on the Remote Commander to select “ Line I/F ” from the launcher menu, then press the PUSH ENTER button. Or pressthe CONNECT/DISCONNECT ( / ) button on the RemoteCommander.2 Use the V or v button on the Remote Commander to select the type of lineto be used, then press the PUSH ENTER button.AUTO: A line for connecting is automatically selected, based on the numberentered in the number text box.IP: Connects to a videoconferencing system on the remote site via a LAN.ISDN: Connects to a videoconferencing system on the remote site via an ISDNline.TEL: Connects to a phone on the remote site via an ISDN line for a voicemeeting.3 Press the V, v, B or b button to select the Direct Phone Book of the remoteparty that you want to call, and then the PUSH ENTER button of theRemote Commander.“Dial” appears.If “More Options Enable” in the Dial Setup menu is set to “On”, you can select the“Details” button. When you do, the Detail Dial menu appears.For details about the Detail Dial menu, see “To call a remote party notregistered in the Phone Book” on page 79.4 Press the V, v, B or b button to select “Dial”, and then press the PUSHENTER button of the Remote Commander.Note
