194 Location and Function of Parts and Controlsg MAIN CAMERA connectorConnect to the TERMINAL connectoron the rear of the Camera.h MAIN AUX IN connector (miniDIN 4-pin)Connect to the video output of externalvideo equipment.i SUB CAMERA connectorConnect to the TERMINAL connectoron the rear of the secondary camera.j SUB AUX IN jack (mini DIN 7-pin)Connect to the video output of externalvideo equipment.k DC 19.5V jackConnect the supplied PCS-AC19V6 ACpower adaptor.l IR OUT 1/2 jacksConnect the supplied IR repeater.Connect the IR repeater for the monitorconnected to the VIDEO OUTMONITOR MAIN connector to the IROUT 1 jack, and the IR repeater for themonitor connected to the VIDEO OUTMONITOR SUB connector to the IROUT 2 jack.m AUX CONTROL connector (D-sub9-pin)Used for maintenance service.n CTRL-S jack (minijack)Connect to the optional RemoteCommander Signal Receptor.The remote sensor of the Camera Unitdoes not operate when this connector isin use.o U (ground) terminalConnect a ground wire.p VIDEO OUT AUX jack (phonojack)Connect to the video input of the TVmonitor or VCR.q VIDEO OUT MONITOR 1connector (mini DIN 4-pin)Connect to the S-video input on the TVmonitor or VCR.r VIDEO OUT MONITOR 2connector (mini DIN 4-pin)Connect to the S-video input on thesecond TV monitor when the systemuses the dual monitor mode.s EC-MIC jacks (1, 2)For future expansion. Not used.t RGB OUT connector (D-sub 15-pin)Connect to the RGB input of theoptional projector or display unit.u WHITE BOARD connectorConnect to the optional mimio Xi.v 100BASE-TX/10BASE-T connector(8-pin modular)Used to conduct a conference via aLAN. Connect to a hub using thecategory 5 cable.w DSB connector (D-sub 15-pin)Connect to the TERMINAL connectoron the optional PCSA-DSB1S DataSolution Box.x ISDN UNIT connectorConnect to the TERMINAL connectoron the optional ISDN Unit such asPCSA-B384S, PCSA-B768S andPCSA-PRI.
